How To Remove Retractable Awning

How Do I Supersede My Retractable Awning Fabric?

https://www.nhawning.com/wp-content/uploads/2015/05/100_0057-Copy-1024x760.jpg 1024 760 New Haven Canopy New Haven Awning https://world wide web.nhawning.com/wp-content/uploads/2015/05/100_0057-Re-create-1024x760.jpg Apr 30, 2022 May 14, 2022

During these times of social distancing and isolation, a lot of us are looking around the house for our next project to go along us busy. Replacing the faded or damaged cloth on your retractable awning is a great fashion to occupy your fourth dimension while making your domicile await even meliorate. Below are all the steps needed to complete the job with equally little frustration every bit possible.

Get the Measurements:

Below the list is an image to assistance yous measure everything correctly. You can utilize this worksheet to keep runway of your measurements.

Measure the verbal width of your retractable cover (The cover will be slightly smaller than your front bar width)
Measure the projection of your awning when fully extended.
* Add 12 inches to the project measurement to let for roller tube wrap.
** Projection measurement does not demand to be exact, yous can circular to the nearest inch
Measure valance height (Normally 6-9 inches)

Club Your Material:

Visit our Retractable Canopy Replacement Covers folio and fill in the required fields and complete your order.
Sit dorsum and relax while we take care of the fabrication. We will notify yous when your lodge ships.

Removing the Existing Retractable Canopy Cover:

Retract the awning fully and secure the folded arms by tying them at elbows to the torsion bar (square bar).
( IMPORTANT) Adjacent, necktie the two halves of the arms together.
Both steps are designed to keep the arms fully closed while you work on the awning.
You can conrm your tying skills by extending the awning a foot or two – if the artillery didn't motility, you tin can proceed to the adjacent step.
Send the awning out approximately i foot.
The fabric volition start to loosely gyre off the top of the roller tube while the framework remains stationary.
Remove front bar terminate caps and fabric locks if equipped. Next, slide the valance out of the front bar, including the PVC tubing.
If awning has a hood, remove pivot end side cover rst
BE Sure Arms ARE 100% SECURED
Your cover ships with new PVC tubing. The tubing volition need to exist trimmed to lucifer the original length of your tubing.
Unroll the canopy cover completely with the crank handle until you see the metallic roller tube and the slot in the tube is facing towards y'all. Mark the roller tube where the cover starts equally a reference signal for the installation of the new cover.
Slide the cover off of the roller tube on the pin side (not the motor or gear side).

Installing the New Fabric On To Your Retractable Awning:

Contrary the steps above!

* When installing the cover, exist careful at the seams as you slide the textile onto the roller tube and front bar.

** Of import… DO Not UNTIE THE Arms UNTIL THE Embrace IS FULLY INSTALLED AND COMPLETELY ROLLED ONTO ROLLER TUBE. THE ARMS ARE Spring LOADED AND Can PUSH FORWARD WITH Bang-up FORCE.

Having trouble? Feel complimentary to contact united states

Bring together our mailing list for coupons and alerts on our new shop items.